Resource to calculate, building and measuring Hi Fi Loudspeakers and more...




 
Wednesday, November 22, 2017
3247 users online


Bookmark and Share


Back to overview

   Tapered Quarter-Wave Tube


Since the TQWP is an oscillation horn, rather than compression, the point of maximum oscillation occurs at the port.
This oscillation is what moves the air in the port.

Notes:
  • This page calculates dimensions based primarily on Fs of driver used, which is obviously not ideal.
  • Line tuning is set to Fs of driver to critically damp it at that frequency.
  • Calculations assume use of 19mm (0.75in) material for walls and interior baffle.
  • Dimensions are internal.
  • Height of intenal baffle should not extend more than the center point of the driver as mounted.

  • This calculator is not expected to give perfect results, but hopefully will be a good starting point.

Qt of the driver used in a TQWT should be between 0.2 and 0.7, best results can be expected if Qt=0.4 .. 0.5.

The length of the TQWT should be agreed on about 1.0 to 1.2 x resonant frequency of the speaker.
The initial cross-section Sa of the TQWT is 75 to 100% of the membrane surface, the end cross section Se is 225 to 300% of the membrane surface.
The center of the speaker should be about 40 to 45% of the total length.
The diameter of the tailpipe Dv should be about half the effective membrane diameter, the length of the tailpipe Lv is about 1.5 x Dv



 
  Driver parameters:  
 
  Driver resonant frequency Fs  [Hz]  
  Driver diaphragm surface Sd  [cm2]  
 
 



Figure not to scale, for illustration and clarification only


H[cm] - Interior height of the TQWT
W[cm]- Inside enclosure width
T1[cm]- Initial interior at the beginning of the TQWT
T2[cm]- Distance Front/interior divisor at the top
D[cm]- Entire interior depth of the TQWT
T3[cm]- Distance of the loudspeaker from the beginning of the TQWT
T4[cm]- Lenght of the divider
Dv[cm]- Diameter of the final pipe
Lv[cm]- Length of the final pipe
Vb[l] - Net volume of the box in litres (without volumes of the reflex pipe)
F3[Hz]- Lower critical frequency of the TQWT ( -3dB )